BARBELL JACK

We have partnered with Intertek a 130 years leading global quality and safety partner, where we test our jacks at 250 kg (550 lb) each side for a plate change duration. We have also imprinted a guidance max weight on the jack, if you're planning to leave a loaded bar on the jack for a longer period.

Our Barbell Jack is suitable for most bars 28 to 32 mm (1.1 to 1.25 in) except for the extra thick Axle bar where the diameter of the grip is almost the same of the diameter of the sleeve at 48 mm (1.9 in)

The gap (or jaw) of the jack is limited at 33mm (1.3 in) with a 5% production margin to avoid users hooking at the sleeve where the weight plates slide in.

Our Barbell Jack does not have any steel or metal material and is not painted. We use high-pressure injection moulded technology and a durable pre-production coloured mix of GF and NYL to deliver strength, quality and stability.

Depends on the design of your bar, some Hex bars have a 28 - 32 mm (1.1 to 1.25 in) diameter section before the 50 mm (2 in) sleeve, in that case Yes it works.

During our development stage our initial design had an opening that could fit the 50 mm (2 in) diameter Trap Deadlift Bar. However; over 35% of our focus groups, ended up hooking it on the sleeve section where the plates slide in on the standard barbell; so we minimised the opening in our jack so that it could only hook on the inner side.

Ideally between the knurl marks and the weight plates stopper ring of a standard barbell, not in the middle of the bar and not more than 20 cm (8 in) from the ring.

You can use the Barbell Jack for both Standard and Olympic plates, they are ideal when setting the 450mm (17.7 in) Olympic, Bumper, Urethane (PU), competition and calibrated plates.

We’ve spotted our barbell jack used by competitors and organisers at the Tasmania’s Strongest and The Coast Games – Functional Fitness Competitions!